Rental Bike Maintenance
Rental Motorbike Headlights Aimed Too High: What to Report

On this page
What should you do if your rental motorbike’s headlight seems aimed too high or to one side? Do a quick wall check, photograph the beam and report it to the shop rather than adjusting the lamp yourself. A beam that points too high dazzles oncoming riders; one that points too low or sideways leaves you unable to see hazards. Signs include oncoming traffic flashing at you on dipped beam, a dark road surface just ahead with glare further away, or one side of the road much darker than the other.
Headlight aim is easy to overlook in daylight at pickup and obvious only after dark. This guide explains why it matters, how to do a rough check, what to watch for while riding and how to describe the problem to the shop.
Why a badly aimed headlight is dangerous
| Problem | Consequence |
|---|---|
| Beam aimed too high | Oncoming riders and drivers are dazzled and briefly lose sight of the road |
| Beam aimed too low or too short | You see obstacles too late, especially at higher speeds |
| Beam pointing to one side | One side of the road is lit and the other is dark; you may miss a pothole or a pedestrian |
| Passenger or heavy luggage at the back | The front of the bike can rise, pushing the beam higher than when riding alone |
The table describes general problems. The correct aim for each model is set by its manufacturer, so a rough check only tells you whether something looks clearly wrong.
A simple wall check at pickup
- Find a flat wall on level ground in a shaded spot. The shadow of an outdoor wall in the evening, or a covered parking area, works well.
- Mark the height of the centre of the headlight on the wall, for example with a small piece of paper level with the lamp.
- Position the bike upright, facing the wall a few metres away, with the rider sitting on it as when riding.
- Switch on the dipped (low) beam and wait for it to settle, keeping the bike straight.
- Look at the beam on the wall. On dipped beam, the bright area’s upper edge should sit below the height of your mark, not above it.
- Check the sides. The beam should not be clearly shifted to one side of the bike’s centre line, although some lamp designs are deliberately asymmetric.
- Photograph the wall with the beam and your mark, with the date and time visible.
This check gives only a rough indication. It does not replace the equipment and judgement of a mechanic. Its purpose is to give you something concrete to show the shop.
Signs you notice when riding after dark
- Oncoming vehicles flash their lights at you repeatedly while you are on dipped beam.
- The road just in front of the bike is hard to see, while the distance is brightly lit.
- One side of the road is noticeably darker than the other.
- The beam jumps up and down much more than expected over bumps.
If you notice these signs, slow down, keep to well-lit roads where possible and tell the shop as soon as you can. The guide to night riding in Hanoi and oncoming dazzle has more on riding safely after dark.
Use dipped and main beam at the right moments
- Use the dipped beam whenever there is oncoming traffic or a vehicle close in front of you.
- Switch from main (high) beam to dipped beam early when you see oncoming traffic in the distance.
- Do not flash the main beam repeatedly in busy streets; it distracts and annoys other road users.
- If you are dazzled, slow down and look towards the right-hand edge of your lane rather than closing your eyes or turning your head away.
With a passenger or luggage
A passenger or heavy load at the rear can lift the front of the bike and raise the beam. Do the wall check with the bike loaded as you will ride it, if possible. If the beam looks noticeably higher with two people, ask the shop whether the lamp has an adjuster and whether it should be set for your trip; do not make the adjustment yourself unless the shop tells you how.
What not to do with a rental bike’s headlight
- Do not remove or prise open the headlight housing to adjust it.
- Do not tape or paint over the lens to reduce glare; it weakens the light and can damage the lamp.
- Do not ride on main beam through town because it seems easier to see.
- Do not ride at night with a beam that is clearly weak or misaligned without telling the shop first.
How to report it to the shop
| Information | Example of what to say |
|---|---|
| Symptom | The dipped beam points high, or pulls to the left |
| How you noticed | Wall check, or oncoming vehicles keep flashing |
| Load | Riding alone, or with a passenger and luggage |
| Photos | Wall photo with the beam and a height mark, dated |
| What you did | Only observed; did not adjust anything |
Nguyen Ha’s rental policy asks riders who notice a fault to stop somewhere safe and contact the shop with their location and a photograph. A headlight problem is no exception.
If the headlight is wrong at pickup
If the beam looks clearly wrong before you leave, say so straight away and ask whether it can be checked or whether another bike is available. Raising it at pickup avoids any later question about whether it changed during your rental. If the light fails completely after dark, the guide on a headlight that fails at night explains how to get out of traffic safely.
Clean the lens and your visor before night rides
Dust or mud on the headlight lens scatters and weakens the light, and a scratched or dirty helmet visor makes oncoming glare worse. Wipe both before setting off at dusk. If your visor is badly scratched, ask the shop for another helmet.
Message to send the shop
Hello Nguyen Ha, I am riding the [model, plate number]. At night, oncoming vehicles keep flashing at me on dipped beam, and a wall check suggests the beam is aimed high [or: to the left]. I am riding [alone / with a passenger]. I have attached a photo and have not adjusted anything. Could you check it, or tell me where to bring the bike?
Frequently asked questions
Why do oncoming drivers flash their lights at me?
Often because they are dazzled, which can mean your headlight is aimed too high or you are on main beam. Check which beam you are using, then do a wall check and report it if needed.
Can I adjust the headlight myself?
Ask the shop first. Some lamps have an adjuster, but changing the setting on a rental bike without guidance can create a new problem.
Does carrying a passenger change the headlight aim?
It can. Extra weight at the back can lift the front of the bike and raise the beam, so check with the bike loaded as you will ride it.
Nguyen Ha Motorbike Rental: Ngõ 5 Nguyễn Văn Cừ, Bồ Đề, Long Biên, Hanoi, Vietnam, open 09:00–21:00 daily. Call +84 334 699 969 if your rental bike’s headlight dazzles oncoming traffic.



